Skip to Content (Press Enter) Skip to Footer (Press Enter)

How to Make a Pyrography Sign

Level
Beginner
Time
1 hour
Budget
10 - 30

Personalise your home with a little pyrography sign! These amazing pyrography signs are the perfect way to jazz up any interior, plus they make a great gift for any occasion from weddings to birthdays! Tutorial by Rachel Richardson.

You will need

Is $ 3.49 , was $ 4.49

Quantity: 1

Subtotal

Is $ 3.49 , was $ 4.49

Is $ 4.49 , was $ 6.49

Quantity: 1

Subtotal

Is $ 4.49 , was $ 6.49

Out of stock

Is $ 6.49

Quantity: 1

Subtotal

Is $ 6.49

Out of stock

Is $ 6.49

Quantity: 1

Subtotal

Is $ 6.49

Out of stock

Is $ 36.00

Quantity: 1

Subtotal

Is $ 36.00

You’ve viewed 2 of 5 products

You’ve viewed 4 of 5 products

Total:

How to make

Heart Sign Step 1

Trace around the heart onto plain paper. This will allow you to sketch designs knowing they will fit the plaque.

Step 2
Once you have your design, copy onto the plaque in pencil.
photo-w.jpg?sw=680&q=85
Step 3
Allow the pyrography tool to heat up for approximately five to ten minutes.
Step 4
Once you have finished burning use a rubber to erase any pencil marks that can be seen.
House Sign Step 1

Measure the plaque. When you create a design allow 5mm around the edge to ensure it fits. The font shown is Marigold, you can find free fonts available with a quick internet search. Once you have created your design, in the settings of your design software flip the image horizontally and print onto tracing paper.

Step 2
Cut off the excess tracing paper and place the ink side down onto the plaque and tape into place.
photo-e.jpg?sw=680&q=85
Step 3

Using the embossing tool, gently rub over the image to transfer the ink onto the plaue. Peel back the paper and check the pressure you have applied is enough.

Step 4
Allow the pyrography tool to heat up for approximately five to ten minutes. Use a round ended tip as it will flow easier when burning.
Square Sign Step 1

Measure the plaque. Chose your design, the fonts shown are Debby and Bite_Bullet, you can find free fonts available with a quick internet search. Print or photocopy onto tracing paper making sure the design is smaller than 14cm x 14cm and trim the excess paper. Tape the tracing paper into position along the top. Place the Graphite Trace Down underneath the tracing paper and tape securely.

Step 2

Trace your design using a hard pencil with medium pressure, check your pressure by lifting both sheets.

Step 3

Allow the pyrography tool to heat up for approximately five minutes.

Step 4

Once you have finished burning you may wish to use a sharp scalpel to gently scratch away mistakes or scorch marks.

photo-t.jpg?sw=680&q=85
  • bvseo_sdk, dw_cartridge, 18.2.0, p_sdk_3.2.0
  • CLOUD, getReviews, 7ms
  • reviews, product
  • bvseo-msg: Unsuccessful GET. status = 'ERROR', msg = 'Not Found.'; Unsuccessful GET. status = 'ERROR', msg = 'Not Found.';

Related Products

Top