3 Card Ideas to Make for Hanukkah
Craft beautiful handmade cards to send to your friends and family this Hanukkah. These three designs vary in complexity so there’s something for everyone!
Using our range of toppers, stamps and card blanks, you can create eye-catching designs that loved ones will display throughout the celebrations.
You will need
Subtotal
Is N/A
Out of stock
Subtotal
Is $ 1.49
Subtotal
Is N/A
Out of stock
Subtotal
Is N/A
Out of stock
Subtotal
Is $ 1.49
Out of stock
Subtotal
Is $ 1.49
Out of stock
Subtotal
Is N/A
Out of stock
Subtotal
Is $ 1.49
Subtotal
Is N/A
Out of stock
Subtotal
Is $ 7.49
Subtotal
Is $ 9.49
Out of stock
Subtotal
Is N/A
Out of stock
Subtotal
Is $ 4.49
Out of stock
Subtotal
Is $ 4.49
Subtotal
Is $ 4.49
Out of stock
Subtotal
Is $ 4.49
Subtotal
Is $ 7.49
Subtotal
Is $ 4.49
You will also need:
*Scissors or craft knife
*A ruler
*Glue
1. Cut the Star of David card blank in half and trim the star panel down to approximately 14x10 cm ensuring to trim the sides evenly. Fix the trimmed panel to the front of the blue card blank using 3D foam pads.
2. Stamp out the sentiment using sticky embossing ink on to a scrap piece of blue card, sprinkle with embossing powder then set with the heat tool.
3. Carefully fussy cut the sentiment. Leave a small amount of blue card showing around the edge.
4. Attach the sentiment to the card front using more 3D foam pads.
1. Cut a panel of white card to approximately 14.5x14.5 cm, use the wooden stamps and blue inks to stamp almost the entire panel.
2. Attach the stamped panel to the front of a 6x6” white card blank using 3mm 3D foam pads.
3. Trim a blue panel of cardstock measuring 14.5x3 cm, stamp out the sentiment using silver metallic ink then quickly add some clear embossing powder over the top. Set this with a heat tool.
4. Attach the sentiment strip to the card front with 1mm 3D foam pads ensuring to leave the white portion at the bottom.
5. Finish off by adding a handful of gold gems here and there over the stamping.
1. Trim a blue panel of cardstock to 14.5x4 cm. Fix this panel to the centre of a white A6 card blank using 2mm 3D foam pads.
2. Attach the gold foil sentiment sticker to a small piece of white card cut to approximately 5.5x1 cm then fix to the card front just under the blue panel using 1mm 3D foam pads.
3. Finish off by attaching the wood stars using wet glue, start by fixing the centre star followed by the other two.
Craft with us at our workshops
Related Products
